Research Achievements 11 페이지 | 포항공과대학교 친환경소재대학원

Community

Research Achievements

Total 189건 11 페이지

29

CML [CML] Prof. Dong-Woo Suh: Influence of initial microstructures on intercritical The present work reports the effect of different initial microstructures on reverse transformation kinetics and morphologies of austenite formed during intercritical annealing in Fe-0.14C-7Mn-1Si (wt-%)mediumMnsteel. Three different initial..

작성자 최고관리자 작성일 2019-01-28
28

CML [CML] Prof. Dong-Woo Suh: Effect of Prior Austenite Grain Size on Hole Expansion Ratio The effect of the prior austenite grain size (PAGS) on the tensile properties and hole expansion ratio (HER) has been investigated. Starting from different PAGS values (4.7 lm and 15.2 lm) obtained by controlling the austenitizing temperatu..

작성자 최고관리자 작성일 2019-01-28
27

CTL [CTL] Fazlollah Sadeghi: Optimizing Grain Selection Design in the Single-Crystal An attempt is made to model the design of grain selection during single-crystal solidification of an Ni-based superalloy by the Bridgman method. Various geometrical designs of the starter block and spiral grain selector are chosen and their..

작성자 최고관리자 작성일 2018-12-31
26

SSL [SSL] Prof. Sung-Joon Kim: Effects of carbon and nitrogen on austenite stability and tensile deformation The austenite stability and deformation behavior of 15Cr-15Mn-4Ni based austenitic stainless steels alloyed with C or N are studied. Stability of austenite against martensitic transformation was enhanced with increasing C or N content, whil..

작성자 최고관리자 작성일 2018-12-31
25

SSL [SSL] Prof. Sung-Joon Kim: Fe-Zn reaction and its influence on microcracks during hot tensile Fe-Zn reaction was investigated by annealing a galvanized 22MnB5 steel sheet at 500–900 ° C for 5 min. The observed Fe-Zn intermetallic compounds within the coating depended on the annealing temperature. As the temperature increased, the c..

작성자 최고관리자 작성일 2018-12-31
24

ADL [ADL] Prof. Yoon-Uk Heo: Determination of Yield Stress in a Duplex Steel with a + c Lamellar Structure Yield stress ry is evaluated in a duplex steel with a + c lamellar structure by calculating the stress for the propagation of pile-up dislocations in one phase into another phase. Effective grain size of a lamella is determined to calculate..

작성자 최고관리자 작성일 2018-11-30
23

ATL [ATL] Prof. Yang Mo Koo: Effect of Al content on Magnetic Domains of {100} Grains in Electrical Steels Magnetic domains of {100} grains in electrical steels with 1.85 ≤ Al ≤ 6.54 wt. % were observed by magneto-optic Kerr microscopy. The characteristics and motion of magnetic domains were correlated with hysteresis loss, anomalous loss and..

작성자 최고관리자 작성일 2018-10-31
22

기타 권세균 교수: ‘합금 이상의 합금’ 고엔트로피 합금에 주목해야 하는 이유 (포스코뉴스룸) 이 기사는 포스코뉴스룸에서 가져왔습니다. https://newsroom.posco.com/kr/%ED%95%A9%EA%B8%88-%EC%9D%B4%EC%83%81%EC%9D%98-%ED%95%A9%EA%B8%88-%EA%B3%A0%EC%97%94%ED%8A%B8%EB%A1%9C%ED%94%BC-%ED%95%A9%EA%B8%88%EC%97%90-%EC%A3%BC%EB%AA%A9%ED%95%B4%EC%95%B..

작성자 최고관리자 작성일 2018-10-29
21

CTL [CTL] Prof. Jung-Wook Cho: Thermal history driven molecular structure transitions in alumino-borosilicate glass The glass network structure governs various thermos-physical properties such as viscosity, thermal, and electrical conductivities, and crystallization kinetics. We investigated the effect of temperature on structural changes in a Na2O-CaOAl..

작성자 최고관리자 작성일 2018-09-30
20

CTL [CTL] Prof. Jung-Wook Cho: oxide metallurgy during AM In laser metal deposition (LMD) process, meltpool oxidation is inevitable due to high working temperature, which results in finely dispersed non-metallic inclusions in the steel matrix. In this paper, characteristics of these inclusion, suc..

작성자 최고관리자 작성일 2018-09-30
19

CSL [CSL] Prof. Youn-Bae Kang: ISIJ International, Vol. 58(2018), No. 7, pp.1257-1266 In order to elucidate possible mechanism causing nozzle clogging during continuous casting of Ti added Ultra Low C (Ti-ULC) steel, thermodynamic analysis and experimental validation were carried out with an emphasis on the chemical reaction..

작성자 최고관리자 작성일 2018-08-31
18

ATL [ATL] Prof. Se Kyun Kwon: Twinning in metastable high-entropy alloys Twinning is a fundamental mechanism behind the simultaneous increase of strength and ductility in medium- and high-entropy alloys, but its operation is not yet well understood, which limits their exploitation. Since many high-entropy alloys..

작성자 최고관리자 작성일 2018-07-27
17

EML [EML] Prof. Sung-Mo Jung: ISIJ International, Vol. 58 (2018), No. 2, pp.2744-281 In a 2 stage-smelting reduction process, it is favorable to lower the reduction degree of iron ore in a pre-reducing unit by lowering its temperature to avoid any troubles due to stickiness of high reduced iron ore. However, less pre-..

작성자 최고관리자 작성일 2018-07-26
16

NO IMAGE

기타 GIFT Pride & Joy "Iljin Prize" Dean of GIFT was awarded a prize called "Iljin Award" on Nov. 21 from the National Academy of Engineering of Korea (NAEK) The NAEK Iljin Award was created to honor engineers from various areas who have contributed distinctively in industr..

작성자 gift 작성일 2010-11-16
15

NO IMAGE

기타 Android Application Compiled by Jae Hoon Jang The first Materials Science related Android Application Compiled by Jae Hoon JangAn Android APP that allows you to use your mobile telephone or tablet to calculate the martensite (alpha and epsilon) and bainite-start temperatures, Ae1 an..

작성자 gift 작성일 2011-03-03
14

기타 Great achievements by Prof. Frédéric Barlat The International Journal of Plasticity (IJP, impact factor 4.516), one of the top journals in the field of mechanics and mechanical engineering, which started about 25 years ago began to list recently on its website the all-time 10 m..

작성자 gift 작성일 2010-11-30

SITE MAP

Introduce

People

Research

Education

Community

Community

Research Achievements

검색